Escalator Graphics L1-EG105

Exhibit Hall 4A / Up to Meeting Room Level

Available

SUGGESTED MATERIAL
3M Control Tac

SUGGESTED CONSTRUCTION
Print graphic in 4 pieces

SUGGESTED SIZE
42’W x 69"H

AVAILABLE SURFACES
Single Sided

ESTIMATED INSTALLATION LABOR
4 Men / 4 Hours

ESTIMATED DISMANTLE LABOR
4 Men / 4 Hours

NOTES

THE INSIDE STEEL IS NOT AVAILABLE FOR BRANDING.

TOOLS:? SQUEEGEE, ?DISH SOAP?, SPRAY BOTTLE, WATER?, PAPER TOWELS?, WINDEX

DIRECTIONS:? BEFORE APPLICATION,? USE THE WINDEX TO REMOVE ANY OILY RESIDUE ON METAL. THIS WILL INSURE ADHERENCE.? MIX COLD WATER AND EIGHT DROPS OF DISH SOAP IN A SPRAY BOTTLE AND SHAKE SOLUTION WELL. NEXT, SPRAY METAL AND GRAPHIC WITH A LIBERAL AMOUNT OF SOLUTION BEFORE APPLYING GRAPHIC TO THE METAL. LINE UP AND LEVEL OUT GRAPHIC ON METAL. USE SQUEEGEE TO REMOVE SOLUTION FROM IN BETWEEN GRAPHIC AND METAL. WIPE THE GRAPHIC CLEAN OF SOLUTION RESIDUE BEFORE MOVING TO NEXT JOB.

DOWNLOAD FILE

  • Escalator Graphics L1-EG105
DIMENSIONS
Dimension not to scale.

Escalator Graphics Opportunities

Every effort has been made to ensure the accuracy of all information contained on this photo. However, no warranties, either expressed or implied, are made with respect to this photo. If the location of building columns, utilities or other architectural components of the facility is a consideration in the construction or usage of a graphic element it is the sole responsibility of the client to physically inspect the facility to verify all dimensions and locations.